Kolner Permacoll Size offers far more flexibility than oil sizes, which dry slowly and have short working times. Permacoll Size dries within 15 to 30 minutes, depending on the thickness and the surface’s remaining porosity. You can apply metal leaf hours or even days later.
Permacoll is designed for metallic surfaces not exposed to weather or excessive wear. It is not burnishable with the Agate Stone Burnisher; instead, use Instacoll Tissue to polish the gilded work.
Permacoll Size is recommended as an adhesive for metal leaf on all non-porous surfaces, whether smooth or textured. Typical uses include preparing frames and decorating sets for theatre, film, window displays, and architectural ornaments.
- Permacoll Size is suitable for metal leaf on all non-porous surfaces, both smooth and textured. For absorbent surfaces, use Permacoll Sealer 123a.
- For interior use only. Permacoll Red is ideal for imitation gold, silver, and copper leaf.
- Permacoll suits both metal leaf and gold powder.
- Not recommended for high-gloss finishes.
- Usage: 100 ml covers approximately 1 square meter of flat surface.
- The Kolner Lettering Brush is recommended for Permacoll Size.
- Please note: The 40 ml size is available in response to high demand for smaller quantities.
Important Limitations To Keep In Mind
Permacoll is for Indoors Only: Permacoll is an acrylic, water-based glue made just for indoor decorative work. It cannot stand outdoor weather or heavy use.
Non-burnishable:
You cannot polish metal leaf applied with Permacoll using an agate stone, but it still dries to a bright, shiny metallic finish.
Kölner Leaf Protect varnish:
Needs Sealing: Imitation metals, especially copper and imitation gold, have base metals like copper and zinc that can tarnish over time. Seal your finished work with a protective varnish like Kölner Leaf Protect.
If you are working with porous surfaces like plaster, stucco, wood, or wood composites, start by sealing them with Kölner Sealer 123-A, thinned with water. Once the sealant is dry, use a soft brush to apply undiluted Permacoll Size.
For non-porous or slightly porous surfaces that are clean and free of dust or grease, such as painted or lacquered wood or plastics, apply Permacoll Size right away. If the Permacoll beads up, which can happen on some plastics, add a drop of liquid detergent to the size to fix this.
Once the surface is dry, it will have an even sheen and look darker. At this point, you can apply any type of metal leaf. If some areas look dull or matte after drying, add another coat of Permacoll Size before moving on. After applying the metal leaf, gently rub the surface with a cotton cloth. Be gentle if you are using real gold leaf.
How To Make Cracking Effects With Permacoll Size
- Use a soft brush to apply Permacoll Size in one direction, ensuring the layer isn’t too thin.
- Once the Permacoll Size is dry, apply gold or silver transfer leaf. Then, rub the metal surface with a cotton ball, moving in one direction.
- Brush a 50% yellow dextrin solution onto the metal surface. To stop the solution from beading up, add a drop of liquid detergent.
- The dextrin layer will start to crack as it dries. Crack width depends on layer thickness and drying speed.
- If you dry the layer faster or make it thicker, the cracks will be wider.
- The cracks will reveal the metal underneath.
- Dextrin can wash off, but it is usually best not to.
- To make the crack lines stand out, rub oil paint in a contrasting colour into them.
- You can protect your work with a clear, non-water-based acrylic coating, as long as the dextrin layer is underneath.












































